7 replies to this topic

[BatWing]

So, I am talking about RESIZE, Atlas and HPG Map.

I just discovered, during a fight (not the best way to discover it..), the ATLAS get stuck at the top part of the map, close to the central pillar. It gets stuck because it has been Resized.

Check this SS:
See those Sparkles? there is where the head get stuck and you see the sparkles because the metal is scratching the roof

In this one, you can clearely see "why" you will get stuck. Note the bumps on the roof, just below the compass tape at SW and W. Stepping under those bumps, the head get stuck, so you can pass that ONLY if you drive in between the 2 bumps.

Here you can really see what is going on. See those "steps" on the floor? when they match with the "Bumps" on the rooof, they cut out those bare inches the Atlas can use to navigate, and the Atlas get STUCK there.

All of this area is a Mine Field for our beloved Fat Giant.

However, keep in mind that ANY other mech that after the Resize is possibly tall as or taller than the Atlas, may incur in this same issue.

[Darth Futuza]

So...is this an intended feature to prevent big mechs from using the top?

[EasyPickings]

Need to check with my Highlander and Executioner, but I expect it'll be the same issue. PGI will have to raise the ceiling on this one.

[Emden]

Atlas still gets stuck on top, near the only black pillar.... Not enough clearance for Atlas still..... small raised areas adjacent to that black pillar is where it gets stuck..... Please fix this and the gimppy limp of the beloved Atlas.... PLEASE!!!!!

[Aleksandr Sergeyevich Kerensky]

How about the black knight and the grasshopper?

[Aggravated Assault Mech]

Just going to necro this. Even the Mauler gets stuck on the tops of the pillars.

Pretty irritating.

[BTGbullseye]

Mad Cat Mk II gets stuck there as well.

[Captain Grayson Lighthorse]

Well, if all of these 'Mechs gets stuck then the Annihilator will get stuck for sure. Come on PGI. This is really ridiculous. There is absolutely no need to have the ceiling that low. How about raising it 2 or 3 meters so this all goes away.