4 replies to this topic

[VXJaeger]

Invalid loadout appears no matter what I do.
1st pic, everything is cool:

2nd pic, I add one SRM6 and side torso armor values go haywire on their own:


In the end, I can't do anykind of build into mech because always "Invalid loadout" comes up. And yes, I have tried to remove armor for different locations, no effect on this.

Edited by VXJaeger, 19 May 2018 - 10:29 AM.

[Tarl Cabot]

Actually, you do not even need to add anything. Save the armor, to Home then back and BOTH side torso's armor will be relocated and reduced by 5 points.


From the patch notes. Whatever they did, a coder furbar it...

Quote

The following 'Mechs have had some of their Arm Structure and Max Armor Points re-distributed from their Arm Locations into their Torso locations:

Jenner
Jenner IIC
Cicada
Jagermech
Stalker
All 'Mechs in a player's inventory affected by this change will have their armor re-set to the stock values.

Edited by Tarl Cabot, 19 May 2018 - 11:07 AM.

[VXJaeger]

Did that, done everything, and still that **** goes invalid.

[Tarl Cabot]

Just tested it. For the 3F(C) and 5S /adding 4N (5M and 3FBL appear to be okay), the front STs refuses to exceed 72pts.. Even setting it to 73pts, save, do something else and it is reset back to 72pts with that one point moved to the AVAIL counter. Tis PGI. There is another thread here about Jenners/Jags, those players are running into the same thing.

Edited by Tarl Cabot, 19 May 2018 - 11:29 AM.

[VXJaeger]

FTS, normal PGI as usual.