What Was The Atm Min Range Again?
#1
Posted 17 October 2019 - 04:58 AM
PS: Why isn't the minimal range there in the tooltips with all the other stats?
And no the graph below gives you nothing in real information other then there is a minimal range, no exact numbers.
#2
Posted 17 October 2019 - 05:38 AM
#3
Posted 17 October 2019 - 05:56 AM
Beside that, I rember that it happend to me too that I fire to close because I turn around, saw a target and get a fire solution and press fire before I took my time looking at the range finder.
Anyway thanks for the info.
Edited by Nesutizale, 17 October 2019 - 05:59 AM.
#4
Posted 17 October 2019 - 06:15 PM
#5
Posted 18 October 2019 - 04:50 AM
#7
Posted 18 October 2019 - 05:50 AM
#8
Posted 18 October 2019 - 06:09 PM
Edited by A1Ste4kSauce, 18 October 2019 - 06:15 PM.
#9
Posted 18 October 2019 - 06:14 PM
Things like range quirks affect it though, in the negative sense that a +10% range is just an idiotic 10% extension on all range parameters instead of +10% on good ranges and -10% or no change on minimum ranges.
#10
Posted 18 October 2019 - 06:43 PM
Most often its because range is, AFAIK, calculated from about the center of the model. The missile launchers can sit a couple of meters out further than that. Also because people will tend to face rush an ATM mech, especially if they're close, mostly because **** atms and the people that use them amirite.
In general tho; you want to be at about 145 meters to truly leverage the sheer skill it takes to get the circle near the square and dump 108 damage into a mech with a skill eagle.
#11
Posted 19 October 2019 - 04:47 AM
LordNothing, on 17 October 2019 - 06:15 PM, said:
Poor woman.
Ignatius Audene, on 18 October 2019 - 05:38 AM, said:
Which is why it's better to shoot the enemy in the back.
Gilgamecc, on 18 October 2019 - 06:14 PM, said:
Things like range quirks affect it though, in the negative sense that a +10% range is just an idiotic 10% extension on all range parameters instead of +10% on good ranges and -10% or no change on minimum ranges.
#12
Posted 19 October 2019 - 07:34 AM
Gilgamecc, on 18 October 2019 - 06:14 PM, said:
I have allways wondered about that. I had hoped that it would be at least made so that the minimal range isn't touched and only max range is changed but all values...
#13
Posted 19 October 2019 - 09:39 AM
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users