3 replies to this topic

[Jalexi]

Have a couple of things I can not seem to find an answer to I could use some feedback on.

1. How do you select a faction after you have setup your Profile and selected Lone Wolf because you didn't know what to select at the time? Is this as simple as just selecting an Allegiance Icon in your Profile? If it is, it seems to be disabled at this time.

2. How do you put Ferro-Fibrous armor on your mech? I have 358 in my Amor tab under Loadout. This is the only place that I see it listed. I have no location to drag it to since all I see is a list of all the Mech segments. On the far left under Mech Info, it shows Armor = Standard. How do I make it so I can use the FF armor? I figured out the Endo Steel for structure, but this armor is driving me batty.

Thanks ahead of time!

[Stickjock]

1. Correct, disabled at this time... can only guess the change from the "old" Forum Profile to the "new" Profile isn't completely finished yet...

2. Next to the "Loadout" tab you use to configure your Mech... you should see one that says "Upgrade" (think that's the one...)... clicking that should show you, on the right hand side, 3 choices for Ferro Fibrous, Endo Steel and Double Heat Sinks...

Hope that helps...

[Adrienne Vorton]

Jalexi, on 31 October 2012 - 01:52 PM, said:

I figured out the Endo Steel for structure, but this armor is driving me batty.

armor is in the same tab, ...there is a "headline bar" with armor (just as "structure" and "heatsinks") , klick that and it should show you the ferro fibrous...

[Cargo Bane]

Be aware that it costs to upgrade and downgrade, last time I checked.