1 reply to this topic

[xXBagheeraXx]

Ive been trying ti figure out something to do with my other two Warhawks. I never EVER use them, and my Prime has long since been mastered...But while i was jerking around in the mechlab i ran into an error. I cannot remove ammo. Every time i try to strip down a mech to start from scratch i get an "Error while trying to save loadout" message and all the equipment i stripped off stays on the mech....Anyone else getting this problem?

Edit: ONLY seems to happen to my Warhawk...I can strip down one of my old stalkers just fine...

Edited by xXBagheeraXx, 01 December 2014 - 06:38 PM.

[The Cheese]

I had that a while ago. Save the mech (using the save button), then strip it, then save it again.

If that didn't work for me, relogging did.