Mcgral18, on 05 October 2015 - 01:35 PM, said:
So, perhaps we can continue the discussion without the Manchild trolling.
What is the largest issue concerning the Clan lasers. Is it range, damage, or Damage/duration.
Range & Damage.
The higher damage effectively allows either:
> the same damage as IS mechs for less tonnage
or
> more damage for similar tonnage.
EX:
6x MLAS vs. 6x CERMLAS
Same tonnage, but 12 extra damage at an extra 50% range
4x CERMLAS vs. 6x MLAS or vs. 3x LLAS
Again, similar damage/heat, but for much less tonnage and same/similar or greater range
The further range means that for every IS laser range bracket there are two potential clan options:
> either one that is shorter ranged, but massively more heat tonnage efficient (or both)
or
> there is one that is longer or similar range for less tonnage
There are a few exceptions, mostly based on pulse laser builds - but they tend to be extremely hot and fairly short ranged.
What I mean by two potential options for clan mechs to compete with IS laser brackets is
6x MLAS
Option 1: 4x CERMLAS - longer range, similar damage/heat profile, less tonnage
Option 2: 6x ERSLAS - shorter range (but not far off), but
half the tonnage at a superior damage/heat profile
6x MPLs
Option 1: 4 to 5 CMPLs - longer range, similar or higher alpha, less tonnage
Option 2: 6x SPLs - shorter range (but not far off), but
half tonnage and superior damage/heat profile
3x LLAS
Option 1: 2x CLPL - longer range, but similar damage/heat for less tonnage
Option 2: 4x CERMLAS - slightly shorter range, but similar damage/heat for
less than one third the tonnage
Mcgral18, on 05 October 2015 - 01:35 PM, said:
I'm not a fan of increasing burn times very much, as with the cERLL the 1.5s duration is already pretty big. I'd rather touch damage down and leave durations in similar spots.
I'm not a fan of it either. I think there is a usability limit before it just becomes unfun/stupid to utilize.
Unlike most people, my first order would be to buff IS lasers.
People can cry about power creep, but too many clan mechs rely too heavily on lasers to just start nerfing the hell out of everything.
1) Increase all IS lasers by roughly 10% range.
SLAS 135 > 160 (a little more than 10% for base usability)
SPL 110 > 135 (more than 10% for usability)
MLAS 270 > 300
MPL 220 > 250
LLAS 450 > 500
LPL 365 > 400
ERLLAS > no change (see below)
2) Slightly adjust some burn times down, instead of increase clan burn up
LLAS 1s > 0.9s
LPL 0.67s > 0.6s (old value)
ERLLAS 1.25 > 1.1
3) Decrease MLAS heat down to 3, SLAS heat down to 1
4) Adjust ghost heat limits
MLAS from 6 to 8
Large Laser and LPL from 3 to 4 (not ERLLAS)
5) Reduce CD times for select weapons
MLAS 3s > 2.25s to match CERSLAS
MPL 3s > 2.25s to match CSPL
I'd start there, and see how things play out.
If necessary, select Clan weapons could have slightly increase CD times, for example CERMLAS from 3.25 to 3.5, etc - or start tweaking some damage values down.
Edited by Ultimatum X, 05 October 2015 - 06:43 PM.