Khobai, on 18 February 2016 - 05:25 PM, said:
I dont see three madcat MK2 variant that use mwo tech
totally different things
- MAL-1K This overhaul replaces the lasers with Snub-Nose PPCs. The autocannons were replaced with the same number of Light Autocannon/5s, along with enough ammo bins to take advantage of special munitions. It's also fitted with an additional double heat sink, giving this version of the Mauler adequate heat-dissipation capabilities. BV (1.0) = ??, BV (2.0) = 1,678[4]
- MAL-1PT5 A low-tech version of the Mauler for the arenas of the Solaris Games that is built completely from stock Succession Wars era technology. It mounts only standard heat sinks instead of double heat sinks, standard armor instead of ferro-fibrous armor, and no CASE. Most importantly, it has a standard engine instead of an XL engine. The increased mass of the engine neccessitates the downgrading of the lasers to Medium Lasers on both arms. To make good for the downgraded technology level, a twelfth standard heat sink was added as well as an additional ton of armor. The armor was also rearranged to provide even better protection to the front torso sections, at the cost of armor to the rear torso sections and arms. (Thecanonicity of this design is questionable, as it was only published in the German edition of theSolaris VII Boxed Set. It is identical to the Linesman in all but name. BV (1.0) = ??, BV (2.0) = ??
- MAL-2R The 2R variant of the Mauler uses relatively new weapons. The standard AC/2s are replaced with Ultra versions thereby doubling their potential damage. Paired ER Medium Lasers are fitted in arms formerly housing the ER Large Lasers. The missile launchers are reduced to smaller LRM-10s. A heavier standard fusion engine is utilized instead of the expensive XL. BV (2.0) = 1,586[5]
- MAL-3R The 3R variant of the Mauler upgrades the design and addresses the concerns of pilots that used the 1R model. The four Autocannon/2s have been replaced with a pair of LB-X Autocannon/10s. The ER Large Lasers were removed from the design, but MAL-3R retains the two LRM-15 launchers of its predecessor. Also incorporated in the design is a single Small Laser and a C3 Slave unit, the latter of which allows the 3R to use targeting data from units that are closer to the enemy and vice versa. It also has a ninety meter jump capability. BV (1.0) = 1,698 (C3: 202)[2][6], BV (2.0) = 1,877[7]
- MAL-C The C variant of the Mauler is a modification that was made to the 1R model to allow it to carry a C3 Slave unit into battle. This is achieved by removing one ton of autocannon ammunition. This small modification allows the Mauler to share targeting data with friendly units and makes the 'Mech a highly effective sniper. BV (1.0) = 1,133 (C3: 261)[2][8], BV (2.0) = 1,473[7]
- MAL-4X "Todesbote" A custom configuration used by a Lyran Commonwealth criminal, this Mauler variant (named "Todesbote" by the LCAF) replaces the standard weaponry of a Mauler with a singleHypervelocity AC/10 in each arm, while the missile racks were replaced by MML-7s. Each autocannon has two tons of ammo while the twin MML-7s use a single ton of ammunition. All ammunition bays are protected by CASE II, and the "Todesbote" is protected by twenty-seven tons of Hardened Armor.[9] BV (2.0) = 1,904[10][11]
Note: "Todesbote" (German: Harbinger of Death) also happens to be the name of the AwesomeBattleMech in the German edition of BattleTech.
Edited by Imperius, 18 February 2016 - 05:33 PM.